This is a 1970 Chevrolet Impala underhood and trunk bolt, nut and screw kit. The kit contains 227 items. This kit may contain screws for more than one model. Disregard any extra screws. The kit includes the following screws, nuts and bolts: battery tray mounting bolts (2), battery hold down bolt (1), battery tray mounting bolts (2), accelerator cable H/D screw (1), accelerator plate screws [block out] (2), ground wire screws at firewall (2), vacuum tank screws at firewall (2), windshield washer bottle mounting screws (2), quarter extension mounting nuts (6), grille screws (6), hood molding nuts (10), header mounting bolts (2), fender to RCS bolts (4), side grille brace mounting bolts (12), center grille brace mounting bolts (2), front wheel well bolts (10), outer wheel well to fender bolts (16), inner wheel well to brace bolts (6), front wheel well bolt u-nuts (10), outer wheel well bolts u-nuts (16), brace to wheel well u-nuts (6), hood latch u-nuts (2), inner wheel well bolt washers (6), rear fender mounting bolts for the rear, lower and at the door jamb (8), hood hinge bolts to hood (4), hood hinge bolts to fender (4), hood latch and catch bolts (7), horn mounting bolts (2), RCS to front support bolts (6), emergency brake mounting nut (2), radiator mounting bolts (4), radiator spacer panel to shroud bolts (4), brace to wheel well bolts (6), front fender brace bolts (2), upper wheel well bolts [less washer] (6), starter relay screw (1), trunk latch and catch bolts (5), front windshield molding screws (5), firewall access screws (3), wiring gutter mounting screws (2), relay screws at firewall (2), A/C expansion valve mounting screws (2), A/C heater housing electrical mounting screws (6), A/C heater housing connecting screws (6), A/C heater housing to firewall screws (6), A/C heater mounting nuts (2), and deck lid hinge bolts (4).